SAFETY NOTICE
FOR OPERATION OF ALL BRANDS OF HYDRAULIC TORQUE TOOLS
POWER TOOLS SHOULD ONLY BE OPERATED WITH...HARD HAT, SAFETY
GLOVES, GOGGLES, STEEL-TOED BOOTS, EAR PLUGS AND WITHOUT
LOOSE CLOTHING.
HANDS-OFF - HYDRAULIC TORQUE TOOLS! IF AT ALL FEASIBLE STAY
DISTANT FROM TOOL UNDER PRESSURE OR HOLD HANDLE IN A SAFE
POSITION!
!!!
Unless there is CLEAR Communication - Tool Operator
Operates Pump !!!
BEFORE
USING HYDRAULIC TORQUE TOOLS, PLEASE RUN THESE SAFETY
TESTS:
* Pressurize tool on the ground and cycle it several times
at maximum pressur to check too, hoses and pump for
function and leaks. Replace hose and fix tool or pump in
case of leak or functioning irregularities prior to use.
* Check tool and reaction arm for cracks and badly worn
areas and replace if so.
* Check socket for cracks and badly worn areas and replace
if so.
* Check backup wrench for cracks and badly worn areas and
replace if so.
PLEASE STAY DISTANT FROM TOOL HOSES AND PUMP DURING SAFETY
TEST.
TOOL
SETUP:
Assure tight screw-connectors (without gap). Set required
pump pressure with tool connected. Firmly connect socket to
drive. FOR TOOL SETUP Loosen screw connectors half a turn
if pump operator is distant from job to avoid inadvertant
startup while handling the tool. Retighten thereafter.
REACTION
ARM SETTING:
The reaction arm of the tool should be placed in the same
direction as the drive. Whenever possible so as to about
firmly against teh adjacent nut or the casing. Please test
by placing tool on the nut, apply pressure to make sure
reacton is firm and tool does not rise. If it does, reset
the reacion arm.
TOOL
HOLDING:
On vertical or inverted applications, please hold tool so
that even if there is a failure of tool or socket that you
are out of harm's way. On horizontal applications, take
hands-off when tool is in use! Request supplier to give you
a free user training prior to first use! Or Call
1-800-FOR-HYTORC
NEVER...
*
Never hold the tool on connectors or swivel during
operation!
* Never place the tool on job without partially
disconnecting both hoses when pump operator is out of
sight.
* Never use leaking tools or hoses!
* Never have your face close to the socket during
operation!
* Never place your hand on reaction arm or swivel when pump
is operating!
* Never place your hand on operating tool if not absolutley
necessary!
* Never use altered, heavily used, damaged or chrome
sockets!
ALWAYS... Always use caution and common sense.
Emergency Support
24/7 Support : 1-800-GO-HYTORC